If you are a
woodworker and often use, a table saw. It’s a particular question for you how to change a table saw blade details?
The answer I will show
step by step process. But you should know when it’s time to change the blade.
Right!
How to know when your blade is dull?
It’s a common problem
for a woodworker. If you have a maintaining routine for this, you don’t need to
worry at all.
But if you are a
newbie or don’t know after how many hard projects you should change those blades.
Make sure you read the
full article to gain this knowledge.
It’s high time to
change your table saw blade when you see these symptoms.
- Bent blade, Alignment problems, these are the common problem.
- But if your blade makes a burn on wood, this is serious, and you need to take the step to change it.
I suggest not to buy a
new one.
You can clean it by
using super washer liquid. Take a half bucket of cleaner and leave
those blades for 20min.
And boom. Your blades
are ready to go like a new one.
As I mentioned if your
blades are facing situation 1. You have to a new table saw blades. Need a
review for this? Visit this link.
Sometimes it’s a wise
decision to sharp the blade instead to buy a new one. But if your blade’s teeth
are broken.
Especially for 80
teeth blade. Don’t be so smart that you can manage with broken teeth, however.
It will hamper your
project that can’t be undone. Take my decision to change it with a new one.
Changing table saw
blade is an essential task for carpenters. So, do it yourself in just 10 min.
What tools do you need
to do it?
- Screwdriver.
- Wrench.
- Of course, the new blade.
- Small block of wood for support.
Caution:
- Turn off the power.
- Wear safety gloves.
Step by step process:
To remove the blade
1st lose the screws. Some edges are a tie with more than one screw.
Make sure you lose all
the screws.
- When you lose the screw, the blade loses tension and start to move. So, use a plank of wood to block it.
- Remove the nut and washer with the help of a wrench.
- Take the new blade and repeat all this thing. Use a wrench to tighten the screws.
- Then install the guard system and throat plate.
- You are now ready to go.
- Turn on the power and make sure the blade is moving correctly.
Conclusion:
Now you know the
procedure correctly. This is a straightforward process, but which part should
you consider fast.
It will never bother
you next time to change the table saw blade. It’s so similar with changing
miter saw blade also.
All I have mentioned in the
article. Thank you. Good luck with your next woodworking projects.
No comments:
Post a Comment